Train canopy growth for
1. Optimal light interception (photosynthesis)
2. Optimal air movement (prevent diseases)
3. Optimal management (rows for equipment)
Easy steps to convert your vineyard for the growing of Ultra-premium wine.
Step 1. Measure from the top of the post to the vine wire, example, 800mm.The metal cross brace length is 500mm + x 50mm pipe.
Cut a 20mm slit cut each end where the wire fits, then tying wire is cut to 200mm length, placed over each wire and twisted off to stop wire falling out.
Step 2. Drill a hole through the post at the 300mm mark from top of post, this is where the metal pipe cross brace is placed.
Step 3. Run the first wire, bottom wire allow running along the ground. Run the second wire and strain until its 600mm above the ground. Run the third wire and allow to sage slightly between each post.
Note: Every second post could be removed to save cost?
Spacers 800mm x 15mm light pipe with cuts at each end for the wires.
Place spacers every second vine, on the first side. Opposite other side. Place top and second wire into spacer and crimp.
Place dog chain link between spacers and bottom wire into spacer bottom and crimp over. Lightly strain. Complete on side then the other. Pull vines over and tie to trellis.
New Crops@thefruitpolecompany prides itself in providing solutions suited to the Horticulture and Viticulture sector.